Front axle housing TeraFlex Tera30 Lift 0-5"

• 3,25" O.D. x 0,5" wall extreme duty axle tube increases torsional strength to resist bending (JL)
• WMS-WMS: 66,5"
• Axle shafts: 27-Spline
• Wheel bolt pattern: 5x5"
• Asymmetric housing design for extra-long tube side strength
• Pre-installed inner axle seals
• HD forged inner knuckles w/ greater upper and lower section strength
• Ductile cast iron housing w/ increased rib gussets
• HD ductile iron differential cover w/ increased cover mounting area
• Smooth radius bottom design to glide over rocks and obstacles
• Integrated lower control arm skid plates
• High-flow oil passages and bottom oil drain hole for simple fluid changes
• UV protected triple-stage powder coat for corrosion resistance
• 1/4"- thick CNC laser cut axle brackets for extreme strength
• Integrated factory location upper control arm mount
• Pre-installed upper control arm bushings
• Proper pinion angle and raised track bar bracket for lifted applications
• Pre-drilled holes on spring perches for bump stop extension bolts
• Retains all factory ESP, ABS, and speedometer sensor capability

Notes:

• Transfer your existing internal components (differential ring and pinion axle shafts) and outer components (stub shafts knuckle assembly ball joints unit bearings brakes sensors) to the new housing!
• Compatible with Dana 30 AdvanTEK (M186) internal components
• Does not work with Front Axle Disconnect
• Factory dront inner right axle shaft does not work with Tera30 HD front axle housing