Rear forged sway bar kit TeraFlex ST Lift 1-6"

• Three adjustable sway bar stiffness settings: center hole matches factory stiffness, further hole softens by approximately 10%, closer hole stiffens by 10%
• Secure arm clamping with two 12 mm bolts providing 27,000 lbs of clamping force to prevent bar splines from loosening over time
• Simple bolt-on installation, no modifications required
• Tightening the torsion bar mounting bolts expands the bushing for a tight, locked-in fit
• Rubber bushings maintain factory noise and vibration levels for a smooth quiet ride
• Adjustable spacers allow for sway bar width adjustment to accommodate different tire sizes and fender liner clearance

In the box:

• Rear forged sway bar ST
• (2) Rear forged sway bar arms
• (2) Rear sway bar links
• Sway bar bushings
• Mounting brackets
• Hardware

Notes:

• Compatible with all JL Wranglers with a minimum 1" suspension lift
• Compatible with all engine configurations
• Requires wheels with minimum 4,75" back spacing
• Requires 2" minimum of added bump stop in the rear
• The Dana 35 Rear Axle that come on Sport and Sahara trims require you have wheel spacers in addition to the other fitment requirements TX1057000 sold separately
• May require trimming of fender liners depending on setup